Wells HDW-2 - Manual (Page 7)

5
INSTALLATION (continued)
ELECTRICAL
Refer to electrical specifications on page 1. Circuit must meet or
exceed the amperage and wattage requirements listed.
120 Volt units require a properly grounded NEMA 5-15R receptacle:
208/240 Volt units require a properly grounded NEMA 6-15R
receptacle:
WARNING:
ELECTRIC
SHOCK HAZARD
All servicing requiring
access to non-insulated elec-
trical components must be
performed by a factory au-
thorized technician.
DO NOT open any access
panel which requires the use
of tools. Failure to
follow this warning can
result in severe electrical
shock.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
CAUTION:
ELECTRICAL
SHOCK HAZARD
The ground prong of the
power cord is part of a
system designed to protect
you from electric shock in the
event of internal damage.
DO NOT cut off the large
round ground prong, or twist
a blade to fit an existing
receptacle.
IMPORTANT:
Contact a licensed electrician
to install and connect
electrical power to the
appliance.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.