weber 3400 Series - Manual (Page 14)

14
Figure 8
Figure 9
Wheel
frame
Caster frame
Figure 10
Step 9
Install the three back panels
You will need: frame assembly, two plastic buttons and the
three back panels. (Number 2)
Place the bottom of one back panel on the back frame
connector, notches to the top. Set in place to the far left,
butting up against the caster frame. Repeat the procedure
with the the other two back panels. Figure 8.
With all three panels in place and flush with each other,
push in the plastic buttons. They should cover the flanges
of the panels up against the wheel and caster frames.
Figure 9.
Step 10
Install side burner locks
You will need: frame assembly, two side burner locks and a
7/16 inch wrench.
Loosen the right rear 1/4 x 20 bolt. Install the side burner
lock. The “U” shape cut out of the lock slips down over the
bolt. Tighten with a wrench. Figure 10 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock
fits between the front panel and the frame. The “U” shape
cut out slips up over the bolt. Tighten with a wrench.
Figure 10 (b).