weber 3400 Series - Manual (Page 15)

15
Burner tubes
Frame brace
Figure 11
Figure 13
Figure 12
(b)
Guide screw
Wing nuts
(a)
(c)
Frame cross piece
Spacer bracket
Keps nut
Bolt
Nylon washer
(a)
(b)
Your Weber Gas Barbecue burner assembly has been
factory assembled, pressure and flame tested. As a safety
precaution we recommend you check the burner alignment:
a) Do the valves fit into the ends of the burners?
Figure 13 (a).
b) Are the ends of the burners under the washers at the
left rear and left front of the cooking box? The screws
are only guides. Do not tighten. Figure 13 (b).
c) Are the wing nuts under the burner assembly hand
tight? Do not tighten with pliers. Figure 13 (c).
If you answered YES to a, b and c, the burners are correctly
aligned. If you answered NO, the burners are misaligned.
Contact your dealer. Do not use your barbecue.
Slide the cooking box to the left within the frame. Put the
washer on the bolt. Take the spacer bracket and hold it up
to the frame making sure both tabs fit underneath the frame
cross piece. Figure 12 (a). Insert the bolt through the center
hole in the spacer bracket, frame and cooking box with the
head of the bolt outside the spacer bracket. Figure 12 (b).
Add the keps nut. Figure 12. Tighten by holding the bolt
with pliers while you tighten the nut with a wrench.
Step 11
Add cooking box
You will need: frame assembly, cooking box assembly,
spacer bracket, 1/4-20 x 2 inch bolt, nylon washer,
1/4-20 keps nut, pliers and a 7/16 inch wrench.
Uncoil the hose.
Set the cooking box into the frame so the burner tubes are
under the frame brace. Figure 11.