Wybron Transition Optic - Manual (Page 10)

10
Fixture Setup and Configuration
Installing the Lamp
DANGER: Disconnect fixture from line voltage before replacing
lamp.
CAUTION: Lamp and lamp mounting surfaces are hot! Allow lamp to
cool 10 minutes before replacing
Lamp Specifications
Lamp socket / base: G22
Part#
UHI-S150DW/A/UVP
Lamp, Eurospot UHI Series 3000K 150W
UHI-S150DM/A/UVP Lamp, Eurospot UHI Series 4200K 150W
CDM150/T6/830 Lamp, CDM 150W with UV Fade Block 3000K
CDM150/T6/942 Lamp, CDM 150W with UV Fade Block 4200K
Figure 1.1
 Disconnect fixture from AC power.
 Remove lamp plate by unscrewing mounting screws and pulling the
lamp assembly straight back from the illuminator.
 Grasping lamp by the base remove old lamp from the socket.
 Insert new lamp into base. Lamp is fully seated when spring clips snap
over lamp base.
CAUTION: Touching the glass lamp envelope can reduce lamp life.
Handle new lamps with a clean cloth. Fingerprints can
be cleaned off the lamp envelope with alcohol and a
clean cloth.
Locating the Fixture
The Transition CMY fiber illuminator is designed to be surface mounted,
located in a cabinet or closet, or hung from mounting pipe with the optional
pipe bracket.
Surface Mounting
The Transition may be surface mounted on a hard surface table,
counter top, or floor (wood, laminate, metal, tile).
Do not mount the Transition on soft surfaces such as carpet, linoleum,
cushions, or fabric.