Weider 831.159833 User Manual
Page 9
9
10. Press a 50mm Square Inner Cap (67) into the
Press Top Frame (9).
Attach the Press Top Frame (9) to the indicated
bracket at the top of the Press Upright (5) with
two M8 x 66mm Bolts (89), a Medium Support
Plate (109), and two M8 Nylon Locknuts (86). Do
not tighten the Locknuts yet.
11. Identify the Left Weight Guides (27), which have
welded rings near the bottom. Slide two Weight
Bumpers (46) onto the Left Weight Guides. Insert
the Left Weight Guides into the indicated holes in
the Center Base (2).
Set the other two Weight Bumpers (46) over the
indicated holes in the Center Base (2). Insert the
Right Weight Guides (26) through the Weight
Bumpers and into the holes in the Center Base.
Make sure the oval holes on the Right Weight
Guides are on the top.
10
11
109
9
86
67
5
26
26
2
46
Welded
Rings
Oval
Holes
27
27
89
12. Attach the indicated Weight Guides (26, 27) to
the Center Base (2) with two M10 x 67mm Bolts
(82), four M10 Washers (97), and two M10 Nylon
Locknuts (90).
2
82
82
97
97
90
90
12