Wells H-006UL - Manual (Page 6)

INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
RISK OF
PERSONAL INJURY
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize
this appliance until all in-
stallation instructions are read
and followed. Damage to the
appliance will result if these
instructions are not followed.
CAUTION:
ELECTRICAL
SHOCK HAZARD
The ground screw of this
appliance must be connected
to a suitable building ground.
IMPORTANT:
Contact a licensed electrician
to install and connect
electrical power to the
appliance.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
Appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
SETUP
Refer to the Installation Instruction Sheet for cutout dimensions and
required clearances. Maintain required clearances between the
appliance and adjacent surfaces.
Unit must be installed such that it can be serviced from the bottom.
If the area beneath is to be used storage, a baffle must be placed 8"
beneath the hotplate to prevent contact with elevated temperatures.
Provided gaskets for hotplate, hotplate adapter ring and control panel
must be used in this installation. Damage caused by failure to use
these gaskets is not covered by warranty.
ELECTRICAL INSTALLATION
Fig. 2 H-006UL Wiring Diagram
Electrical flex-conduit is provided to allow the hotplate to be located
up to 32" from the control panel. Excess conduit must be coiled and
secured to prevent damage. DO NOT cut the conduit or wiring.
Unauthorized alteration of the conduit or wiring voids the warranty and
UL listing.
Connect field wiring to provided pigtail with wire nuts (not provided).
4