External gps installation, Roof installation, Before beginning installation, refer to drawing – Winegard AS-2003 User Manual

Page 14

Advertising
background image

14

Roof installation

The length of this cable MUST BE 53 inches
from back of electronics housing to clamp. NO
CLAMPS ALONG THIS 53” LENGTH!

First cable
clamp here!

CENTER LINE

OF COACH

ROOF

The length of this cable MUST BE 53 inches
from back of electronics housing to clamp. NO
CLAMPS ALONG THIS 53” LENGTH!

FRONT OF

VEHICLE

DRIVER
SIDE

PASSENGER
SIDE

BEFORE BEGINNING INSTALLATION, REFER TO DRAWING

9. GPS antenna can be installed within 3’ of the first cable clamp. It must have

a clear view of the sky to operate properly, and should have a level location.

10. Install away from air conditioners, satellite antenna and mount, or any other

roof-mounted equipment.

11. Decide where your GPS antenna will be located. Clean roof area with an

approved cleaner for your roof material.

12. After placing the GPS in the desired location, do not secure. Test your

system before securing permanently.

13. To permanently secure the GPS antenna, carefully peel the backing off the

tape on the bottom of the unit, then press down on the roof.

14. To prevent movement of the GPS wire, secure with an approved sealant

every 6”.

GPS antenna

GPS wire
36” long

4” MINIMUM from

first clamp to

cable-entry plate

Cable-entry

plate

20”

4”

EXTERNAL GPS INSTALLATION

Advertising
This manual is related to the following products: