Wasp Bar Code WLS 9500 - Manual (Page 101)

Symbologies 7-13
UPC/EAN/JAN Supplemental Redundancy
With Autodiscriminate UPC/EAN/JAN Supplementals selected, this option adjusts the number of times a symbol
without supplementals is decoded before transmission. The range is from two to thirty times. Five or above is
recommended when decoding a mix of UPC/EAN symbols with and without supplementals, and the autodiscriminate
option is selected. The default is set at 7.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in Appendix C, Numeric
Bar Codes . Single digit numbers must have a leading zero. To correct an error or change a selection, scan Cancel on
page C-4 .
Transmit UPC-A Check Digit
The check digit is the last character of the symbol used to verify the integrity of the data. Scan the appropriate bar code
below to transmit the bar code data with or without the UPC-A check digit. It is always verified to guarantee the integrity
of the data.
UPC/EAN/JAN Supplemental Redundancy
*
Transmit UPC-A Check Digit
Do Not Transmit UPC-A Check Digit