Wasp Bar Code WLS 9500 - Manual (Page 18)

WLS 9500 Product Reference Guide 1-4
Setting Up the Scanner
Installing the Interface Cable
To connect the interface cable:
1. Insert the interface cable’s modular connector clip into the cable interface port on the bottom of the scanner
handle.
(See
Figure 1-2 .).
2. Gently tug the cable to ensure the connector is properly secured.
3. Connect the other end of the interface cable to the host. (See the specific host chapter for information on host
connections.)
Figure 1-2. Installing the Cable
Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. Actual connectors may be different than those illustrated, but the steps to connect
the scanner remain the same.
Interface cable
modular connector
To host
Cable
interface
Interface cable
modular connector clip