weber Summit 56221 - Manual (Page 14)

14
2
1
3
4
5
m always open the lid before igniting the burners.
A) Each control knob has its own igniter electrode built in . To create a spark you must
push the control knob in (1) and turn to START/HI (2) .
B) This action will generate gas flow and a spark to the burner lighting tube (3) . You will
hear a “snap” from the igniter . You will also see a 3 - 5 orange flame coming from the
burner lighting tube at the left side of the burner
(4) .
C) Continue to hold the burner control knob in for two seconds after the “snap”.
This will allow gas to flow completely down the burner tube
(5) and insure ignition .
D) Check that the burner is lit by looking through the cooking grates . You should see
a flame . If burner does not light on first try, push control knob in and turn to OFF .
Repeat lighting procedure a second time .
m warninG: if the burner still does not light, turn the burner
control knob to off and wait 5 minutes to let the gas clear
before you try again or try to light with a match.
◆
SNAP IGNITIoN oPERATIoN