weber 56070 - Manual (Page 15)

IGNITER
If the Ignition system fails to ignite the side burner, light the burner with a match.
• Check that both ignition wires are attached properly.
• You should hear the igniter sparking.
REPLACE BATTERY IF NECESSARY
AAA alkaline battery only. See illustration:
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site.
Log onto www.weber.com
® .
15
WWW.WEBER.COM ®
SIDE BURNER MAINTENANCE
ƽ WARNING: All gas controls and supply valves should be in the
“OFF” position.
Make sure ignition wires(1) are connected between the igniter and electrodes.
Make sure grounding wire(2) is connected between the igniter and grounding clips on the
burner cups.
Spark should be a white/blue color, not yellow.
1) Igniter
Wires
2) Ground wire
3) Burner
SIDE BURNER TROUBLESHOOTING
1
1
2
3
GENERAL MAINTENANCE
PROBLEM CHECK CURE
Side Burner does not light. Is gas supply off? Turn supply on.
Flame is low in “HI” position Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? If match lights burner, check igniter (see below).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
® .