WhisperKool EXTREME 5000TIR - Manual (Page 16)

Page 16 PT-EXPL5000 060311
Mounting Bracket Installation
There are four individual mounting brackets, one for each side of the unit. There will be two long brackets and
two short brackets: upon receiving the unit these brackets will be located on top of the packaging foam on top
of the unit. These brackets are designed to mount toward the rear of the unit and mount to the exterior side of
the cellar wall. On each panel of the unit there are two half-shears for each bracket, and four different locations
for mounting the brackets. Align the holes on the mounting bracket with the half shears on the unit, depending
on the desired mounting location, secure using the 1/2” self tapping screws provided. Refer to the illustration
below for the location of the half shears.
#2. Retrofit your current WhisperKOOL
cooling unit
#3
#1
#4
THROUGH-THE-WALL INSTALLATION (without ductwork)
Applying Insulation Tape
Locate the four precut pieces of black
foam tape included with the system.
There should be two larger pieces and
two smaller pieces. Once you have at-
tached the flange pieces to the unit, peel
back the white-paper adhesive covering
and place on the corresponding size of
flange. The large pieces are applied to
the side and the smaller pieces to the top
and bottom. This foam creates a tight seal
between the flange and the wall.
Front of unit
Back of unit