Weider WEBE19510 - Manual (Page 10)

15. Wrap the Low Cable (24) around a 3 1/2” Pulley
(16). Attach the Pulley and a Cable Trap (26) to the
bottom set of holes in the Pulley Plates (27) with an
M10 x 45mm Bolt (18) and an M10 Nylon Locknut
(20).
Make sure the Cable Trap is turned to hold
the Cable in the groove of the Pulley. Do not
overtighten the Nylon Locknut; the Pulley must
be able to turn freely.
14
16
20
18
3
24
Ball
10
16. Attach the Low Cable (24) to the bracket on the
Rear Base (8) with an M10 x 20mm Bolt (21) and
an M10 Nylon Locknut (20).
17. Wet the ends of the Lat Bar (38) with soapy water.
Slide a Handgrip (39) onto each end of the Lat Bar.
18. Make sure all parts are properly tightened before
you use the weight rack. The use of all remaining
parts will be explained in ADJUSTMENTS, beginning
on the following page.
15
16
17
26
16
24
21
24
20
8
38
39
39
Bracket
20
27
18
14. Locate the Low Cable (24). Lay the Low Cable in
the bracket on the Base (3) so that the ball is on
the indicated side. Attach a 3 1/2” Pulley (16) to the
bracket with an M10 x 45mm Bolt (18) and an M10
Nylon Locknut (20).
Do not overtighten the Nylon
Locknut; the Pulley must be able to turn freely.