Weider WEBE19510 - Manual (Page 8)

8
6. Press a 60mm x 50mm Bushing (13) into the top
of the Carriage Stop (14). Slide the Carriage Stop
onto the lower end of the Rear Upright (2). Attach
the Carriage Stop to the indicated hole in the
Rear Upright with an M8 x 70mm Bolt (25) and an
M8 Nylon Locknut (28).
Orient the angled top of the Rear Upright (2) as
shown in the inset drawing. Slide the Rear
Upright onto the bracket on the Rear Base (8).
Attach the Rear Upright to the Rear Base using
two M10 x 65mm Bolts (19), four M10 Washers
(15), and two M10 Nylon Locknuts (20).
Do not
tighten the Nylon Locknuts yet.
20
2
28
8
Base
Hole
25
19
15
15
6
13
14
29
22
12
6 20
12
4
2
19
20
15
15
8
15
15
19
6
20
16
17
17
23
9
13
13
21
2
7
40
40
Bracket
Weight Tube
9. Locate the High Cable (23), which is the shorter
of the two cables. Route the metal-sleeve end of
the High Cable up through the indicated slot in
the Top Frame (6).
Wrap the High Cable (23) around a 3 1/2” Pulley
(16) as shown. Attach the Pulley inside the slot in
the Top Frame (6) with an M10 x 65mm Bolt (19),
two M10 Washers (15), two 15mm x 10.5mm
Spacers (17), and an M10 Nylon Locknut (20).
Do not overtighten the Nylon Locknut; the
Pulley must be able to turn freely.
7
7. Press 60mm x 50mm Bushings (13) into the top
and bottom of the Weight Carriage (7). Press
25mm Round Inner Caps (40) into the ends of the
weight tube on the Weight Carriage.
Insert an M10 x 20mm Bolt (21) into the bracket
on the Weight Carriage (7).
Slide the Weight Carriage (7) onto the Rear
Upright (2) as shown.
Be sure the Weight
Carriage is turned so that the bracket is at the
top on the side shown.
8. Press two 50mm Square Inner Caps (12) into the
ends of the Top Frame (6).
Slide the bracket on the Top Frame (6) into the
Rear Upright (2) as shown. Attach the Top Frame
to the Rear Upright with two M10 x 65mm Bolts
(19), four M10 Washers (15), and two M10 Nylon
Locknuts (20).
Attach the Top Frame (6) to the Crossbar (4) with
two M10 x 80mm Bolts (22), a Support Plate (29),
and two M10 Nylon Locknuts (20).
Tighten all of the M10 Nylon Locknuts (20)
used in steps 1–8.
High Side
Toward
the Base
2