Williams Sound Transmitter T36 - Manual (Page 12)

BELT CLIP INSTALLATION
To Install: Position the belt clip on the rear of the device as shown in FIG 8A. Turn the belt clip 180°
left or right as shown in FIG 8B. The belt clip is now installed and ready for use.
To Remove: Turn the belt clip 180° so the open end of the clip points to the top of the unit as shown in
FIG 8A. Gently pull the belt clip away from the unit to remove.
CHANNEL SELECTION CHART
For convenience, the T36, R36, and R33 all use the same frequencies in the same positions on their
channel selection switches.
11
H e l p i n g P e o p l e H e a r
10
H e l p i n g P e o p l e H e a r
FIG. 8A FIG. 8B
FIG. 9