Williams Sound Transmitter T36 - Manual (Page 7)

7. Lapel clip microphones should be attached to a collar or lapel, as close to the speaker’s mouth
as practical. If using an optional headset microphone, position the mic as close to the side of the
mouth as possible without touching the mouth See FIG 3.
8. To mute the microphone, press the “ON/OFF/MUTE” button momentarily. The “ON/OFF/MUTE” but-
ton will flash red. To unmute the microphone, press the “ON/OFF/MUTE” button momentarily again.
IMPORTANT: When the T36 transmitter is not being used, remember to turn the unit OFF by press-
ing and holding the “ON/OFF/MUTE” button for three seconds. The Power On indicator will not be lit.
GAIN CONTROL
The gain control can be used to adjust the volume level on both the microphone and auxiliary input. To
adjust the volume level, open the battery door and locate the Gain Control (see FIG 4). Use the sup-
plied small screwdriver and rotate to increase “+” or decrease “-” the gain.
FIG. 3: Lapel Microphone Placement
5
H e l p i n g P e o p l e H e a r
4
H e l p i n g P e o p l e H e a r
AA
AA
–
+
+
–
Comp CH Lock - Gain + - AUX +
2:1
1:1
FIG. 4: ConFIGuration Controls
1 2 3 4
1. Gain Control 3. Compression Selector
2. Auxiliary Input Level 4. Channel Lock
Yes Yes No