Wyse Technology WintermTM 9000 - Manual (Page 16)

xiv
Class B
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.
IEC/EN Notice
These products conform to the requirements of IEC950 and EN60950.
These products conform to requirements of EN55022 for Class A equipment or EN55022
for Class B equipment (refer to “Terminal Requirements Compliance”).
Caution
For use with supplied power adaptor. Replace only with the same or
equivalent type as recommended by the manufacturer.
Model 9235LE Terminals
For use with External Power Supply DVE Model DSA-0301-05 or certified equivalent
model supplied by the manufacturer.
Model 9440XL Terminals
For use with External Power Supply Flytech/CARRY-I Model FT-8006A or certified
equivalent model supplied by the manufacturer.
Noise Suppressor
A noise suppressor (ferrite bead) must be installed on the network cable of your terminal.
This installation is necessary to maintain compliance with U.S. FCC B limits and European
CISPR B EN55022 Class B limits. The noise suppressor is supplied by the manufacturer
and is packed in your terminal’s shipping carton.
Cable Notice
The use of shielded I/O cables is required when connecting this equipment to any and all
optional peripheral or host devices. Failure to do so may cause interference and violate
FCC and international regulations for electromagnetic interference.