Yamaha EMX100RDS - Manual (Page 28)

E-20
To stop program play
• Press the stop button. The first programmed track
number will be displayed.
• To resume playback, press the play/pause / button.
Playback will begin from the beginning of the program.
To cancel a programmed sequence
There are several methods as described below.
• Press the stop button while the unit is stopped.
•
Open the disc table
• Turn this unit into the standby mode.
To check program data
1. If during playing back, press the stop button.
2. Press the PROG button.
3. Each time the
button is pressed, the track numbers
and sequential order of the programmed tracks can be
checked one after another. The display of the track
number can be returned (sequentially in reverse order) by
pressing the
button.
To correct program data
1. Follow the procedure described in “To check program
data”.
2. Display the track number to be corrected by pressing the
or button.
3. Press a track number input button to select a track to
replace the one displayed. The previously programmed
track will be cleared from the memory and the new one
will be programmed.
4. When the correction is finished, press the PROG button
or play/pause / button once again.
COMPACT DISC PLAYER OPERATION
CD CHANGER RECEIVER EMX–100RDS
PHONES
DISC 1 2 3
PROGRAM
MUSIC
USER MEMORY
INPUT SELECTOR VCR/LD-TV/CD/TUNER/TAPE•MD/AUX VOLUME
RANDOM
DISPLAY MIC
MIN MAX
MIC MIXING
REPEAT TIME MEMORY AUTO/MAN'L
HOUR PRESET/TUNING/BAND A/B/C/D/E MIN TIME ADJ TIMER
OPEN/
CLOSE
DISC
CHANGE
STANDBY/ON
MODE PTY SEEK START FREQ PS/PTY/RT/CT
PTY SELECT PTY SELECT
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B C D
+ I0
E
OPEN/CLOSE RANDOM REPEAT MODE
6
6
7
7
8
8
9 0
CD
PRESET
TUNER
STOP
INPUT
PLAY/PAUSE
LEVEL MUSIC
TEST FLAT CENTER/REAR
/DELAY
PROGRAM USER
STANDBY/ON
DISPLAY SLEEP
VOLUME
/
PROG
/