Yamaha Clavinova CLP-320 - Manual (Page 34)

Keyboard Stand Assembly
CLP-320 Owner’s Manual 34
ENGLISH
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the stand on the flat floor surface.
• Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of
incorrect screws can cause damage or malfunction of the product.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Remove all parts from the package and make sure you
have all of the items.
1.
Attach (finger-tighten) C to D
and E.
1-1 Untie and straighten out the bundled pedal
cord. Don’t discard the vinyl tie. You will
need it later in step 6.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening the
long screws 1 (6
× 20mm).
Have a Phillips-head (+) screwdriver of the
appropriate size ready.
D
A
B
C
E
Bundled pedal cord
inside
AC Power cord
Assembly Parts
6 × 20 mm long screws Ч4 1
6 Ч 16 mm short screws Ч4 2
4 Ч 12 mm thin screws Ч2 3
4 Ч 20 mm tapping screws ×4 4
Cord holders × 2
Headphone hanger set
4 × 10 mm thin screws ×2 5 Headphone hanger
L
1-2
1-1
1-3
E
C
D
32