Yamaha Clavinova CLP-320 - Manual (Page 35)

Keyboard Stand Assembly
CLP-320 Owner’s Manual 35
ENGLISH
2.
Attach B.
Depending on the model of Clavinova you pur-
chased, the surface color of one side of B may be
different from the other side. In this case, position
B so that the side of the surface color similar to D
and E faces the player.
2-1 Place the lower side of B on each foot of D
and E, then attach the upper side to D and
E.
2-2 Attach the top of B to D and E by finger-
tightening the thin screws 3 (4
× 12mm).
2-3 While pushing the lower part of D and E
from outside, secure the bottom ends of B
using two tapping screws 4 (4
× 20mm).
2-4 Insert the other two tapping screws 4 (4 ×
20mm) into the other two screw holes to
secure B.
2-5 Securely tighten the screws on the top of B
that were attached in Step 2-2.
3.
Securely tighten the screws on C
that were attached in Step 1-3.
4.
Mount A.
5.
Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws 2
(6 × 16mm) from the front.
R
L
E 2-2, 2-5
2-4
2-3
2-1
D
B
2-3
Place the bot-
tom ends of the
rear panel on
each foot.
3
C
B
R
A
D
E
B
Be sure to place your hands at
least 10 cm from either end of the
main unit when positioning it.
At least
10 cm
CAUTION
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the illustration.
5-1
A
A
5-2
Projection
of A
33