Yamaha HTR-5170 - Manual (Page 23)

21
English
WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise this
unit may be damaged.
If this unit fails to turn on when the STANDBY/ON switch is
pressed:
The IMPEDANCE SELECTOR switch may not be set to
either end. If so, set the switch to either end when this unit
is in the standby mode.
Select the position whose requirements your speaker system
meets.
(Upper position)
Rear: The impedance of each speaker must be 6
Ω
or
higher.
Center: The impedance of the speaker must be 6
Ω
or higher.
Main: If you use one pair of main speakers, the impedance
of each speaker must be 4
Ω
or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 8
Ω
or higher.
(Lower position)
Rear: The impedance of each speaker must be 8
Ω
or
higher.
Center: The impedance of the speaker must be 8
Ω
or higher.
Main:
<
Except Canada model
>
If you use one pair of main speakers, the impedance
of each speaker must be 8
Ω
or higher.
If you use two pairs of main speakers, the
impedance of each speaker must be 16
Ω
or higher.
< For Canada model only >
The impedance of each speaker must be 8
Ω
or
higher.
Ⅵ
IMPEDANCE SELECTOR switch
IMPEDANCE SELECTOR
: 6 Ω MIN. /SPEAKER
: 6 Ω MIN. /SPEAKER
A OR B: 4 Ω MIN. /SPEAKER
A B: 8 Ω MIN. /SPEAKER
SET BEFORE POWER ON
REAR
CENTER
MAIN
: 8 Ω MIN. /SPEAKER
: 8 Ω MIN. /SPEAKER
A OR B: 8 Ω MIN. /SPEAKER
A B:I6 Ω MIN. /SPEAKER
REAR
CENTER
MAIN
CAUTION SEE INSTRUCTION
MANUAL FOR CORRECT SETTING.
REAR
(SURROUND)
SWITCHED
AC OUTLETS
60Hz
I00W MAX.TOTAL
I20V
(U.S.A. model)
IMPEDANCE SELECTOR
Note on main speaker connections:
One or two speaker systems can be connected to this unit. If you
use only one speaker system, connect it to either the
SPEAKERS A or B terminals.
Note on a subwoofer connection:
You may wish to add a subwoofer to reinforce low frequencies or
to output low bass sound from the subwoofer channel when
reproducing discrete signals.
When using a subwoofer, connect the SUBWOOFER terminal of
this unit to the INPUT terminal of the subwoofer amplifier, and
connect the speaker terminals of the subwoofer amplifier to the
subwoofer.
With some subwoofers, including the Yamaha Active Servo
Processing Subwoofer System, the amplifier and subwoofer are
in the same unit. Such a subwoofer needs only the connection
between the SUBWOOFER terminal of this unit and the INPUT
terminal of the subwoofer.
(Refer to page 22 for details about the SUBWOOFER terminal.)
PREPARATION