Yamaha HTR-5170 - Manual (Page 27)

25
English
• After completing all connections, plug the AC power cord
into an AC outlet. • Unplug the AC power cord from the AC outlet if this unit is
not to be used for a long period of time.
IMPEDANCE SELECTOR
: 6 Ω MIN. /SPEAKER
: 6 Ω MIN. /SPEAKER
A OR B: 4 Ω MIN. /SPEAKER
A B: 8 Ω MIN. /SPEAKER
SET BEFORE POWER ON
REAR
CENTER
MAIN
: 8 Ω MIN. /SPEAKER
: 8 Ω MIN. /SPEAKER
A OR B: 8 Ω MIN. /SPEAKER
A B:I6 Ω MIN. /SPEAKER
REAR
CENTER
MAIN
CAUTION SEE INSTRUCTION
MANUAL FOR CORRECT SETTING.
REAR
(SURROUND)
SWITCHED
AC OUTLETS
I00W MAX.TOTAL
VOLTAGE SELECTOR
(General model)
Plugging in this unit
AC OUTLET(S)
(U.S.A., Canada, China, Singapore and General models)
.......................................................... 2 SWITCHED OUTLETS
(Australia model).................................. 1 SWITCHED OUTLET
Use these to connect the power cords of your components to
this unit.
The power to the SWITCHED outlets is controlled by this unit’s
STANDBY/ON switch or the remote controller’s POWER and
STANDBY keys. These outlets will supply power to any
connected unit whenever this unit is turned on.
The maximum power (total power consumption of components)
that can be connected to the SWITCHED AC OUTLET(S) is
100W.
Voltage Selector (China and General Models
only)
The voltage selector on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the
AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
PREPARATION
(*1): (*2):
(*1)
(*2)
To AC outlet