Yeoman EXMOOR YM-W9001FL - Manual (Page 26)

26 26
MAINTENANCE and sERVICING
2. REMOVAL OF THE LOG GUARD
2.1 See Section 2 Fitting & Removal of Log Guard in Installation
section.
3. FITTING AND REMOVAL OF THE BAFFLE
3.1 See Section 3 Fitting & Removal of The Baffle in Installation
section.
4. FITTING AND REMOVAL OF FIREBRICKs
4.1 See Section 4 Fitting & Removal of Firebricks in Installation
section.
5. FITTING AND REMOVAL OF THE
RIDDLING MECHANIsM
5.1 See Section 5 Fitting & Removal of The Riddling Mechanism
in Installation section.
6. FITTING A NEW DOOR GLAss
6.1 To maintain the safe use of your appliance you may need to
replace a damaged door glass. To complete this operation:
• Remove the door, by opening, removing the hinge pins
and lifting the door free of the hinge blocks
• Lay the door face down on a soft flat surface, to protect
the paintwork and glass
PR7528
Fixing Screws (x4)
Fixing Clips (x4)
Glass
Glass Seal (3mm)
Door
1 Door
PR7529
Fixing Screws (x8)
Fixing Clips (x8)
Glass (x2)
Glass Seal (3mm)
Door (x2)
2 Door
6.2 Using a screwdriver remove the glass clip fixing screws.
The old glass can then be lifted clear of the door. (Note
how the 3mm sealing rope is placed between the glass and
the door.) Remember to dispose of the old glass and rope
safely.
6.3 Clean, and re-paint, the rear of the door if required
ensuring all old glue is removed from rope seal channel.
Clean the screws with light oil and coat with high
temperature anti-seize grease, this will aid future removal.
6.4 Fit a new sealing rope between the new glass and the door,
and place the glass into position in the door. Place the glass
fixing clips into position and re-fix with the clean fixing
screws, tighten the screws evenly until the clips hold the
glass. Do not over tighten the clips as this could break
the glass.
6.5 Fit only Yeoman ceramic glass, which is suitable to use in
high temperature applications.
6.6 Using the stove with a damaged door glass could cause
dangerous fumes to enter the room, or the stove to over-
fire, resulting in damage.
7. FITTING A NEW DOOR sEAL
7.1 To maintain the safe use of your stove you may need to
replace a damaged or worn door sealing rope. To complete
this operation, use this method.
7.2 Remove the door from the stove, by opening and lifting the
door free of the hinge pins. Then lie the door face down on
a soft flat surface, to protect the paintwork and glass.
PR7530
Joint
Seal 14mm
1 Door