ZyXEL Communications P-2602HW(L) Series - Manual (Page 310)

P-2602H(W)(L)-DxA Series User’s Guide
310 Chapter 25 Tools
25.7.5 TFTP Command Configuration Backup Example
The following is an example TFTP command:
tftp [-i] host get rom-0 config.rom
where “ i ” specifies binary image transfer mode (use this mode when transferring binary files),
“ host ” is the ZyXEL Device IP address, “ get ” transfers the file source on the ZyXEL Device
( rom-0 , name of the configuration file on the ZyXEL Device) to the file destination on the
computer and renames it config.rom.
25.7.6 Configuration Backup Using GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.
Refer to Section 25.3 on page 302 to read about configurations that disallow TFTP and FTP
over WAN.
25.8 Using FTP or TFTP to Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your device
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
Table 122 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host Enter the IP address of the ZyXEL Device. 192.168.1.1 is the ZyXEL Device’s default IP
address when shipped.
Send/Fetch Use “Send” to upload the file to the ZyXEL Device and “Fetch” to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the ZyXEL Device. The filename for the firmware is “ras” and for
the configuration file, is “rom-0”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.