ZyXEL Communications M-302 - Manual (Page 47)

M-302 User’s Guide
Chapter 4 ZyXEL Utility Configuration 47
The following table describes the labels in this screen.
3 If you selected Infrastructure network type in the first screen, select WEP, WPA, WPA-
PSK or 802.1x from the drop-down list box to enable data encryption. If you selected
Ad-Hoc network type in the first screen, you can only use WEP encryption method.
Otherwise, select DISABLE to allow the M-302 to communicate with the access points
or other peer wireless computers without any data encryption and skip to step
5 .
Figure 31 Profile: Security Setting: Encryption Type
4 The screen varies depending on the encryption method you select in the previous screen.
The settings must be exactly the same on the APs or other peer wireless computers as
they are on the M-302.
Figure 32 Profile: Security Setting
Table 15 Profile: Wireless Setting: Select a Channel
LABEL DESCRIPTION
Wireless Settings
Wireless Mode When configuring for an Ad-Hoc network 802.11b mode is used.
Channel Select a channel number from the drop-down list box. To associate to an Ad-Hoc
network, you must use the same channel as the peer computer.
Back Click Back to return to the Add New Profile screen.
Next Click Next to confirm your selection and advance to the Encryption Type screen.
Exit Click Exit to discard changes and return to the Add New Profile screen.