Yamaha YST-SW160/90 - Manual (Page 5)

5
English
Connecting to this unit’s OUTPUT/INPUT terminals
For connections, keep the speaker wires as short as possible.
(Cut the excessive wire, if necessary.) If the connections are faulty,
no sound will be heard from the speakers. Make sure that the
polarity of the speaker wires is correct, by observing + and –
markings. If these wires are reversed, the sound will be unnatural
and will lack bass.
Do not let the core of the speaker wires touch each other
and do not let them touch the metal parts of this unit as this
could damage this unit, your amplifier and/or speakers.
How to Connect:
Red: positive (+)
Black: negative (–)
1 Unscrew the knob.
2 Insert the core of the
wire. [Remove
approx. 5 mm (1/4”)
insulation from the
speaker wires.]
3 Tighten the knob to
secure the wire firmly.
* Banana Plug connections are also possible (except for U.K.
and Europe models). Simply insert the Banana Plug connec-
tor into the corresponding terminal.
Using two units
Speaker terminals
To AC outlet
Right speaker
This unit
Left speaker
This unit
To AC outlet
Amplifier
Disconnect your main speakers from the amplifier if connected, and connect them to the speaker terminals of this unit.
OUTPUT INPUT2 PHASE BASS
TO SPEAKERS
INPUT1
FROM AMPLIFIER
LOW HIGH
AUTO
STANDBY
NOM REV MOVIE MUSIC
OFF
OUTPUT INPUT2 PHASE BASS
TO SPEAKERS
INPUT1
FROM AMPLIFIER
LOW HIGH
AUTO
STANDBY
NOM REV MOVIE MUSIC
OFF
POWER ON OFF
POWER ON OFF
OUTPUT INPUT2 PHASE BASS TO SPEAKERS
INPUT1 FROM AMPLIFIER LOW HIGH
AUTO STANDBY
NOM REV MOVIE MUSIC
OFF
OUTPUT INPUT2 PHASE BASS TO SPEAKERS
INPUT1 FROM AMPLIFIER LOW HIGH
AUTO STANDBY
NOM REV MOVIE MUSIC OFF