Start the programme, Altering a programme, Interrupting a programme – Zanussi ZWF 1011 W User Manual

Page 9: Cancelling a programme, Opening the door after the programme has started, At the end of the programme

Advertising
background image

9

6. Start the programme

Before starting the machine check that:

the appliance is plugged in

the water supply tap is turned on

the drain hose is correctly and securely positioned

the door and the detergent dispenser drawer are
closed.

To start the selected programme, press
the “Start / Pause” button; the corresponding light
stops flashing.

Only the “washing” light stays on.

7. Altering a programme

You can alter the programme before it starts.
When the programme has started, you can only reset it
by turning the programme selector dial to O and then
you can select the new programme.
The washing water remains in the tub.
Start the new programme by depressing the
Start / Pause” button.

8. Interrupting a programme

Depress the “Start / Pause” button to interrupt a
programme which is running, the corresponding light starts
to flash. Depress the button again to restart the programme.

9.Cancelling a programme

Turn the selector dial to O to cancel a programme which
is running. Now you can select a new programme.

10. Opening the door after the

programme has started

First set the machine to pause by pressing the “Start /
Pause
” button. Wait two or three minutes for the door
lock to be released.

If the machine is already heating, or the water level is
above the bottom edge of the door or the drum is
turning, it means that the door can not be opened.
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector
dial to “O”. After about 2 minutes the door can be
opened (pay attention to the water level and
temperature!).

11. At the end of the programme

The machine stops automatically.

If the

(rinse hold) option has been selected, the

phase light “End” is on to indicate that the water must
be emptied out before opening the door.
To do this first turn the programme selector dial to “O
and then to drain programme

or spin programme

.

Release of the lock is indicated by the illumination of
the “End” light.

Turn the programme selector dial to “O” to switch the
machine off.
Remove the laundry from the drum and carefully check
that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.

35.292.995…ZWF 1011 W.qxd 08/09/2005 12:49 Página 9

Advertising