Yamaha RX-V363 - Manual (Page 15)

11
En
Connections
PREP
ARA
TION
English
Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty,
this unit cannot reproduce the input sources accurately.
■ Before connecting to the SPEAKERS
terminal
A speaker cord is actually a pair of insulated cables
running side by side. Cables are colored or shaped
differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (red)
terminals of this unit and your speaker. Connect the plain
cable to the “–” (black) terminals.
Remove approximately 10 mm (3/8”) of insulation
from the end of each speaker cable and then
twist the bare wires of the cable together to
prevent short circuits.
Connecting speakers
Caution
• Use speakers with the specified impedance shown on the rear panel of this unit.
• If you are to use 6 ohm speakers, be sure to set “SP IMP.” to “6
ΩMIN” before using this unit (see page 12).
• Before connecting the speakers, make sure that this the AC power plug is disconnected from the AC wall outlet.
• Do not let the bare speaker wires touch each other or let them touch any metal part of this unit. This could damage
this unit and/or speakers.
• Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the
speakers away from the monitor.
L R L R
L R
L
R
L
R
DOCK COMPONENT VIDEO
HDMI
VIDEO
AUDIO MULTI CH INPUT
DIGITAL INPUT
OUTPUT
ANTENNA SPEAKERS
1
2
3
DVD DTV/CBL DVR
DVD
DVD
COAXIAL
OPTICAL
CD
DTV/CBL
DTV/
CBL
DVD OUT DTV/CBL SURROUND CENTER FRONT B
FRONT A
MONITOR
OUT
MD/
CD-R
SUB WOOFER
OUT (REC) IN (PLAY)
DVR
DVD FRONT CENTER
SUBWOOFER
SURROUND DTV/CBL DVR CD
IN OUT
IN OUT
MONITOR OUT
AM
GND
FM
75 UNBAL.
Y
P R
P B
Subwoofer
Center
speaker
Front speakers (B)
Left Right
Surround speakers
Front speakers (A)
Left Right
Left Right
10 mm (3/8”)
01EN_RX-V363_U.book Page 11 Friday, December 7, 2007 5:44 PM
Black process 45.0° 240.0 LPI