Yamaha RX-V363 - Manual (Page 62)

58
En
Troubleshooting
■ iPod
In case of a transmission error without a status message appearing in the front panel display, check the connection to your iPod (see
page 18).
■ Bluetooth
Note
Status message Cause Remedy
See
page
Connect error There is a problem with the signal path
from your iPod to this unit. Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit. 18
Try resetting your iPod. —
Unknown iPod The iPod being used is not supported by
this unit. Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported. —
iPod connected Your iPod is properly stationed in a
Yamaha iPod universal dock (such as
YDS-10, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.
Disconnected Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-10,
sold separately) connected to the DOCK
terminal of this unit. Station your iPod back in a Yamaha iPod universal
dock (such as YDS-10, sold separately) connected to
the DOCK terminal of this unit. 18
Status message Cause Remedy
See
page
Searching... The Bluetooth adapter and the Bluetooth
component is in the middle of the pairing.
The Bluetooth adapter and the Bluetooth
component is in the middle of establishing
the connection.
Completed The paring is completed.
Canceled The paring is canceled.
BT connected The connection between the Yamaha
Bluetooth adapter (such as YBA-10, sold
separately) and the Bluetooth component
is established.
Disconnected The Bluetooth component is disconnected
from the Bluetooth adapter (such as
YBA-10, sold separately).
No BT adapter The Bluetooth adapter is not connected to
the DOCK terminal. Connect the Yamaha Bluetooth adapter (such as
YBA-10, sold separately) to the DOCK terminal. 18
01EN_RX-V363_U.book Page 58 Friday, December 7, 2007 5:44 PM
Black process 45.0° 240.0 LPI