Xerox 4508 - Manual (Page 53)

T h e R e m o t e C o n t r o l P a n e l ( R C P )
C h a p t e r 5 : U s i n g S o f t w a r e T o o l s ❖ 5-15
Status Monitor
for DOS
Switch to the directory which contains the DOS Status
Monitor.
• To Start Status Monitor for DOS, at the DOS prompt, type
“DOS4508 1” and press enter.
• The Status monitor is enabled with a required numeric
parameter. A maximum of two digits is accepted.
DOS4508 XX
The XX parameter value has three meanings:
— 0 deinstalls the Status Monitor TSR.
— 1-98 is the polling time period in seconds.
— 99 disables polling.
• The Status Monitor for DOS is a TSR program that
automatically displays messages from the printer.
• For more information, type “DOS4508”and press enter.
Note
If you run the Status Monitor for DOS under graphic mode, it
doesn’t display messages. Only a beep can be heard.
Caution
Do not use the Software Tools for DOS while running DOS
under Microsoft Windows.
4508-c05.frm Page 15 Wednesday, May 22, 1996 7:09 AM