Xantrex Technology XC1524 - Manual (Page 40)

Installation
2–14 975-0187-01-01
Drip Protection Rubber Boots
Xantrex recommends that you install the supplied rubber boots over the XC Series
DC terminals to provide drip protection.
To install rubber boots:
1. Before making the DC connections to the charger, feed the rubber boot over the
charger end of the DC cables.
2. Perform all other DC connections as described in “To install DC wiring:” on
page 2–3.
3. After the DC cables are connected to the charger, slide the boot up the cables
and over the DC terminals. If you are only using one battery, slide the spare
boots over the unused DC terminals.
XC_Charger_Owner.book Page 14 Friday, August 12, 2005 3:23 PM