Xerox 16 Series - Manual (Page 63)

Starting a Job 2-21
2
3 Click on the On-line Finishers tab. The window will display as shown
below.
Figure 2-19: On-line Finishers tab
4 Verify that the profile for the Downstream device to be used is
Enabled.
l
For punching and stacking the 11" edge in the Xerox High Capacity
Stacker, ensure the HCS profile is Enabled.
l
For punching and stacking the 8.5" edge, ensure the GBCSE
profile is Enabled.
l
For all other applications, ensure the profile that associates with the
Downstream device to be run is Enabled.
(In the figure above is an example of a job being sent to a Signature
Booklet Maker.) If this profile is not visible in this window,
go to step 8. If this profile is visible but not Enabled (green check-mark
in the Enabled column), highlight the profile and click Enable and then
click Close.
On-line
Finishers
Tab