Xerox XR6 Series - Manual (Page 15)

Installation
14 Xerox© LCD Monitor User’s Manual
Method 2: Digital (DVI) Connection (XR6-19Dw only)
1
Turn off the computer and unplug the power cable.
2
Connect the signal cable (DVI) to the DVI port on the back of
the computer.
3
Connect the power cord to the LCD monitor and wall outlet.
4
Press the button, located on the bottom side of the main
unit to turn the monitor on, then turn the computer on. If the
monitor displays an image, the monitor is successfully
installed. If no image is displayed, check all connections.
Connect to power source
XR6-19Dw
3
2 Connect to the DVI port
NOTE:
When the DVI and VGA input ports are connected at the same
time, press down the AUTO button after 3 seconds to switch
between the VGA mode and DVI mode.