Connections – Yamaha 506 User Manual
Page 8
E-
4
PREPARATIONS
Connections
Never plug in this unit and other components until all connections are completed.
•
Before making any connections, switch OFF the power to the unit and the amplifier or other components.
•
Connections should be made to the correct input terminals of the amplifier or other components.
•
If the placement of this unit causes noise in other equipment, such as a tuner, separate them from each other.
Choose one of the ways listed below to connect this unit to your amplifier.
When the LINE OUT (analog) terminals of this unit are used (
1
)
•
Be sure that the left (
L
) and right (
R
)
LINE OUT
terminals are connected to the corresponding (left and right) terminals of
the amplifier or other components.
•
Connect the
LINE OUT
terminals to the “CD” (or “AUX”) terminals of the amplifier. For additional details concerning
these connections, refer to the operation instructions for the amplifier being used.
•
The
LINE OUT
terminals of this unit are numbered !. When connecting this unit with a YAMAHA amplifier or receiver
whose terminals on the rear panel are numbered as !, @, #, etc., connect the
LINE OUT
terminals of this unit to the
input terminals numbered ! on the rear of the amplifier or receiver.
When the DIGITAL AUDIO OUT (OPTICAL) terminal of this unit is used (
2
)
•
Before using this terminal, remove the terminal’s cover by pulling it.
•
Make the connection from this terminal to the optical input terminal of an amplifier by using a commercially available
optical fiber cable.
* Be sure to use a high quality optical fiber cable. Other cables might not function correctly.
•
Be sure to attach the terminal cover when this terminal is not being used in order to protect the terminal from dust.
•
CDC-906 only
Set the level of signals output into an amplifier to max. by using the
OUTPUT LEVEL –/+
buttons.
R
L
1
LINE OUT
DIGITAL AUDIO OUT
OPTICAL
DIGITAL IN
ANALOG IN
CD
OPTICAL
R
L
R
L
1
LINE OUT
DIGITAL AUDIO OUT
OPTICAL
To AC outlet
2
Optical fiber cable
(not included)
1
Pin cable
(included)
Amplifier