Yamaha CRW4001t - Manual (Page 12)

Chapter 2 - Installing the Yamaha CRW4001t Drive
6
♦ Setting the CRW4001t as the MASTER
♦ Setting the CRW4001t as the SLAVE
♦ CSEL (Cable SELect)
If you use the CSEL setting, the MASTER/SLAVE setting will be made
automatically depending on the hardware configuration.
For details refer to the manual of your computer.
T
CSEL
SLAVE
MASTER
IDE INT
As shown in the diagram at the right, insert the
jumper pin into the right edge of the jumper
switch.
Note: If only the CRW4001t will be connected to the
IDE interface connector, connect the CRW4001t
to the end of the connector.
As shown in the diagram at the right, insert the
jumper pin into the middle of the jumper switch.
T
CSEL
SLAVE
MASTER
IDE INT