Zanussi FCS 1020 C User Manual

Page 18

Advertising
background image

With a suitable spanner unscrew and remove the three

screws and their spacers on machine's rear.

The three holes must then

be plugged with the plastic

plug caps supplied in the

bag containing the in-

struction booklet, which

can be found inside the

drum.

Positioning

Install the machine on a flat hard floor. Make sure that air

circulation around the machine is not impeded by carpets,

rugs etc. Check that the machine does not touch the wall

or furniture. Level the washing machine by raising or

lowering the two front feet. If necessary, check the setting

with a spirit level. Any necessary adjustment can be made

with a spanner. Accurate levelling prevents vibration,

noise and displacement of the machine during operation.

Caution! Never place cardboard, wood or similar

materials under the machine to compensate for any

unevenness in the floor.

Water inlet

Warning! This appliance must be connected to a

cold water supply
Caution! Before connecting up the appliance to new

pipework or to pipework that has not been used for

some time, run off a reasonable amount of water to flush

out any debris that may have collected

Caution! Do not use the hose from your previous

appliance to connect to water supply.

Connect the hose to a tap

with a 3/4” thread. Always

use the hose supplied with

the appliance.

The machine end of the in-

let hose can be turned in

any direction. Set the hose

correctly by loosening the

ring nut. After positioning

the inlet hose, be sure to

tighten the ring nut again

to prevent leaks.

The inlet hose must not be lengthened. If it is too short

and you do not wish to move the tap, you will have to

purchase a new, longer hose specially designed for this

type of use.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the plastic hose

guide supplied with the machine.

In this case, make sure the end cannot come unhooked

when the machine is emptying. This could be done by

tying it to the tap with a piece of string or attaching it to

the wall.

In a sink drain pipe with a trap.

18

Advertising