Yamaha 2 EZ-AG - Manual (Page 12)

12 EZ-AG
Playing the EZ-AG
When you’re set up and ready, turn on the power and play!
1
Turn on the power.
With the AC power adaptor connected or with batteries installed, simply
press the power switch until it locks in the ON position. When the instrument
is not in use, be sure to turn the power off. (Press the switch again so that it
pops up.). The “YAMAHA” name will scroll across the EZ-AG frets when
the power is turned on. You can stop this by simply pressing any fret.
2
Play chords.
Form a chord with your left hand
(frets you press up to the sixth fret will
glow red), then play the strings with
your right hand.
Power On & Play
• Make sure that external ampli-
fication gear is off when turn-
ing the EZ-AG power on or off.
• A very small amount of power
is used by the EZ-AG when the
[STANDBY/ON] switch is in the
STANDBY position. Be sure to
remove the batteries or unplug
the AC Power Adaptor if you
will not be using the EZ-AG for
an extended period of time.
Adjust the Overall Volume
While playing the EZ-AG strings, adjust the instrument’s volume for the desired overall listening level.
1) Press the [VOLUME] button once or twice so that “u u u uo o o oL L L L” appears on the display.
“uoL” will show on the display while the [VOLUME] button is held, then the current volume
setting will appear when the button is released.
2) Use the VALUE [+] and [-] buttons to set the desired volume level.
PLAY MODE
2 VALUE
TEMPO
CAPO
VOLUME
TUNING
RESET STRUM
START/STOP
CHORD
START/STOP
BOTH
START/STOP
DEMO
START/STOP
SOUND
SELECT
SONG
SELECT
3 1
uoL “uoL” will appear
on the display.
PLAY MODE
2 VALUE
TEMPO
CAPO
VOLUME
TUNING
RESET STRUM
START/STOP
CHORD
START/STOP
BOTH
START/STOP
DEMO
START/STOP
SOUND
SELECT
SONG
SELECT
3 1
7
• Default volume can be restored
by pressing both [+]/[-] buttons
simultaneously.
• Strings that are sounding can be muted by
touching the bridge plate with the edge or heel of
your right hand. Be sure to touch the plate on the
back of the neck with your left hand while touch-
ing the bridge plate with your right hand.
• The sensitivity of the mute sensor will vary
according to the player and ambient humidity. If
muting does not seem to be working properly try
touching the mute plate with the palm of your
hand to increase the area of contact.
10