Yamaha SLG-100S - Manual (Page 8)

8
Tuning
Use a tuning meter, pitch pipe, tuning fork, piano, etc., and tune the open strings to
the pitches shown below.
• If the string’s pitch is high, loosen the string until the string’s pitch is slightly lower than the tuning pitch,
then tune while raising the string’s pitch.
1F 2F 3F 4F 5F
1.
Play the standard pitch “lah” (A3: 440Hz) on a tuning fork, etc., and tune the open 5th string to the
same pitch.
2.
Play the pitch produced by pressing the 5th string at the 5th fret, and tune the open 4th string to the
same pitch.
3.
Play the pitch produced by pressing the 4th string at the 5th fret, and tune the open 3rd string to the
same pitch.
4.
Play the pitch produced by pressing the 3rd string at the 4th fret, and tune the open 2nd string to the
same pitch.
5.
Play the pitch produced by pressing the 2nd string at the 5th fret, and tune the open 1st string to the
same pitch.
6.
Play the pitch produced by pressing the 6th string at the 5th fret, and tune the pitch at the 5 th fret of the
6 th string to the pitch produced by the open 5 th string.
Open 1 st String’s Pitch: E
Open 2 nd String’s Pitch: B
Open 3 rd String’s Pitch: G
Open 4 th String’s Pitch: D
Open 5 th String’s Pitch: A
Open 6 th String’s Pitch: E
Open 1 st String’s Pitch: E
Open 2 nd String’s Pitch: B
Open 3 rd String’s Pitch: G
Open 4 th String’s Pitch: D
Open 5 th String’s Pitch: A
Open 6 th String’s Pitch: E
02_slg100s_en.pm65 06.8.22, 11:05 AM 8