Zoom modeling amp FIRE-15 - Manual (Page 11)

Using the FIRE-15
11 ZOOM FIRE-15
H INT
• You can use a modulation effect and a delay/reverb effect simultaneously. If necessary, perform the above
steps again for the other effect.
• In program mode, you can call up a patch and change the effect setting.
• When the effect in the selected patch is off, you can select an effect type and setting value by performing
steps 1 - 3.
• When the effect in the selected patch is on ([MODULATION] key or [DELAY/REVERB] key LED lit), you can
press the key whose LED is lit to call up the effect type and setting value onto the display. You can then
use the VALUE [
Q]/[W] keys to change the effect type and/or setting value.
Loading and storing patches
The FIRE-15 offers a bank of ten read/write user patches (U) and a bank of ten read-only preset
patches (P). Patches in each bank are numbered 0 - 9.
This section explains how to call up stored user patches or preset patches and how to save
amplifier and effect settings in a user patch.
◆ Loading a patch
1.
Press the [PROGRAM/BANK] key in the patch section, so that the LED lights up.
The current settings of the knobs and controls on the panel become inactive, and the settings of
the patch shown on the display are enabled.
2.
Use the [
Q]/[W] keys to select the bank and number of the desired patch.
With the [
Q
]/[
W
] keys, you can cycle through the patches in the order U0 - U9 → P0 → P9 ...
For information on factory default patch contents, see page 23.
When you press the [PROGRAM/BANK] key, the patch number stays the same and only the bank
is toggled: U1 → P1 → U1.
3.
Operate the controls in the input/preamp section and the effect section as required, to
adjust the distortion, tone, volume, effect type and intensity, etc.
Patch number Patch bank
(U: User bank; P: preset bank)
4