Zoom modeling amp FIRE-15 - Manual (Page 12)

Using the FIRE-15
12 ZOOM FIRE-15
If a control has been operated after a patch was loaded, a dot appears at the bottom right of the
display. This indicates that the contents of the patch have changed. (When you return to the
original settings, the dot disappears.)
H INT
You can store the contents of a changed user patch by pressing the [STORE] key. For information on the
procedure, see the section "Storing a patch".
N OTE
If you have changed some settings and then select another patch, the settings of the previous patch will
return to the stored condition. If you want to preserve your changes, store the user patch.
◆ Storing a patch
N
OTE
When you store a patch, any patch currently stored under the same number will be overwritten (erased and
replaced with the new settings). Take care not to accidentally erase a patch that you want to keep.
1.
Use the knobs and keys on the panel to establish the desired sound.
2.
Press the [STORE] key in the patch section.
The indication "U" (for user bank) and the patch number (0 - 9) are shown on the display. In this
condition, storing the settings as a user patch is possible.
3.
Use the [
Q]/[W] keys to select the desired user patch (U0 - U9).
The preset patches (P0 - P9) are read-only. They cannot be selected as target for storing a user
patch.
Lit
4
0
1