Five speaker configuration, Four speaker configuration, Press the test button to run the dolby test – Yamaha RX-V890 User Manual

Page 16

Advertising
background image

16

7

STOP

VCR 1

VCR 2

V–AUX

CHAPTER/CH

+

DISPLAY

MASTER
VOLUME

+

TEST

MUTING

+

+

+

DSP

HALL

EFFECT

CHURCH

CENTER LEVEL

REAR LEVEL

DELAY

TIME

MOVIE THEATER

JAZZ CLUB

STADIUM

PRO LOGIC

SURROUND

SPORTS

ENHANCED

ROCK

THEATER

70mm

TV

1

2

3

4

5

6

7

8

9

10

ON/OFF

RESET

CLEAR

8

9

+

7

8

Select the center channel output mode according to your
speaker configuration.
(Refer to “SPEAKER CONFIGURATION” on page 7.)

CENTER

MODE

NORMAL

WIDE

PHANTOM

• If your video monitor is on, the state of the test tone output

is also shown by an image of an audio listening room on the
screen.

• The test tone from the left rear speaker and the right rear

speaker will be heard at the same time.

9

Turn up the volume using the remote
control transmitter.
You will hear a test tone (like pink
noise) from the left front speaker, then
the center speaker, then the right front
speaker, and then the rear speakers, for
about two seconds each. The display
changes as shown below.

TEST

MASTER
VOLUME

Press the TEST button to run the Dolby
test.

In step 7, when you select the center mode, note the
following.

Five speaker configuration

NORMAL:

Select this mode when you use a
center speaker that is smaller than the
front main speakers. In this mode, the
bass tone will be output from the
front speakers.

WIDE:

Select this mode when your center
speakers are approximately the same
size as the front speakers.

Four speaker configuration

PHANTOM:

Select this mode when you do not
have a center speaker. The center
channel sound will be output from
the left and right font speakers.

Advertising