Yamaha RX-V890 - Manual (Page 17)

17
Note:
• If the center channel mode is in the “PHANTOM”
position, the sound output level of the center speaker
cannot be adjusted. This is because in this mode, the
center sound is automatically output from the left and
right front speakers.
• If you press the LEVEL +/– switch without previously
pressing the CENTER, or REAR switch, the last
channel selected will be changed.
10
12
11
STOP VCR 1
VCR 2
V–AUX
CHAPTER/CH
— +
DISPLAY
MASTER
VOLUME
—
+
TEST
MUTING
+
+
+ —
—
—
DSP
HALL EFFECT CHURCH
CENTER LEVEL
REAR LEVEL
DELAY TIME
MOVIE THEATER
JAZZ CLUB STADIUM
PRO LOGIC
SURROUND
SPORTS
ENHANCED
ROCK
THEATER 70mm TV
1 2 3 4
5 6 7 8
9 10 ON/OFF
RESET CLEAR
13
12
11
Notes:
• Once you have completed these adjustments, you can
adjust whole sound level on your audio system by using
the VOLUME control (or the MASTER VOLUME keys
on the remote control transmitter).
• If you use external power amplifiers, their volume
controls may also need to be adjusted to achieve the
proper balance.
If there is insufficient sound output from the center
and rear speakers, you may decrease the front speaker
output level by setting the FRONT LEVEL switch on
the rear panel to “–10 dB”.
10
11
12
13
Adjust the BALANCE control so that the test tone sound
output level of the left front speaker and the right front
speaker are the same.
Adjust the sound output level of the rear speakers to be
at the same level as that of the front speakers with the
REAR LEVEL keys.
Adjust the test tone sound output level of the center
speaker to be at the same level as that of the front
speakers with the CENTER LEVEL keys.
Cancel the test tone.
BALANCE
5 5
4
3
2
l 0 l
2
3
4
L R
TEST
CENTER
LEVEL
REAR
LEVEL
PRO LOGIC
The previous mode is selected.