Zhone Technologies 6212-I2 - Manual (Page 62)

Advanced Setup
62 6212-I2 4-Port Router User’s Guide 6212-A2-ZB23-10
Modulation Methods
The following modulation methods are supported by the 6212 ADSL router:
z
G.dmt Enabled
z
G.lite Enabled
z
T1.413 Enabled
z
ADSL Enabled
z
Annex L Enabled
z
ADSL2+ Enabled.
Do not change this setting unless so directed by your ISP.
Phone Line Pair
The 6212 ADSL router supports phone lines on pins 2 and 3 or pins 1 and 4 to
connect your ADSL line. If your phone system uses pins 2 and 3, attach a
normal RJ11 cable to the router and select "Inner pair" on the screen; if your
phone system uses pins 1 and 4, attach the phone with the supplied RJ11 cable
and select "Outer pair" on the screen.
Capability
The following are included under Capability:
z
Bitswap Enable
z
SRA (Seamless Rate Adaptation) Enable
Do not change these settings unless so directed by your ISP.
DSL Advanced Settings
Do not change the DSL Advanced Settings unless so directed by your ISP. To
view the DSL Advanced Settings screen, click on the Advanced Settings
button on the DSL Settings screen (see
Figure 69 ).
There are five test modes between the router and your ISP:
z
Normal test: Puts the router in a test mode in which it only sends a
Normal signal.
z
Reverb test: Puts the router in a test mode in which it only sends a Reverb
signal.
z
Medley test: Puts the router in a test mode in which it only sends a
Medley signal.