X10 Wireless Technology UR86A - Manual (Page 13)

25 24
I
NSTALLING
H
OME
A
UTOMATION
C
OMPONENTS
T
RANSCEIVER
M
ODULE
The Transceiver Module (sold separately)
receives radio frequency (RF) commands
from the MouseRemote to operate a lamp
or appliance plugged into it. The
Transceiver Module also passes on
commands over your house wiring to
control other X10 Modules. Note that
(unlike the Lamp Module) you cannot
dim and brighten a lamp connected to the
Transceiver Module.
You should locate the Transceiver
Module centrally in the home for
maximum range when controlled by the
MouseRemote.
1. Set the House Code
to ‘A’ .
2. Plug a lamp or
appliance into the
Transceiver Module.
3. Plug the Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
UNIT CODE
DIAL
HOUSE CODE
DIAL
H
OUSE
C
ODES AND
U
NIT
C
ODES
Each Module has a specific address made
up of a House Code (red dial on the face
of the Module) and a Unit Code (black
dial on the face of the Module).
The Controller first sends an address and
then a command on the AC power lines.
Only the Module with a matching address
will execute the command. If more than
one Module has the same address, both
Modules will execute the command.
Addresses are set on the Module by
turning the two dials on the front of the
Module to the desired letter and number
(using a small screwdriver or a coin). The
House Code is selected from the letters A
through P, and the Unit Code is selected
from the numbers 1 through 16.