Adjusting color – Xerox COLORQUBE 8870 User Manual
Page 166
Troubleshooting
ColorQube 8570/8870 Color Printer
User Guide
166
To set the PostScript driver print-quality mode from the printer control panel:
1.
Select Printer Setup and then press the OK button.
2.
Select PostScript Setup > OK.
3.
Select Print-Quality Mode > OK.
4.
Select the desired mode and press OK.
PCL Driver
Set the print-quality mode for the PCL driver on the printer control panel or from CentreWare IS.
To set the PCL driver print-quality mode from the printer control panel:
1.
Select Printer Setup and then press the OK button.
2.
Select PCL Setup > OK.
3.
Select Enhanced Mode and then press OK to change the setting to On for Enhanced Mode, or Off,
for Standard Mode.
Adjusting Color
This section includes:
•
•
Note:
This section applies to the PostScript printer driver only.
Color can be adjusted to approximately match the medium used to display it, such as RGB for your
computer monitor, and CMYK color and Spot color for printing.
Automatic Color Correction
Automatic color correction can be set at the printer control panel and in the PostScript driver settings.
For setting color correction in the driver, see
To automatically calibrate color at the printer control panel:
1.
Select Printer Setup and then press the OK button.
2.
Select PostScript Setup > OK.
3.
Select Color Correction > OK.
Print-Quality Mode
Type of Print Job
PCL Standard (default)
General-purpose mode for full-speed printing.
PCL Enhanced
Best mode for presentations. Produces superior text resolution and
vibrant, saturated color prints.