Zenoah Sweeper RMSZ2500 - Manual (Page 15)

6. Set up
15 
SE4
■ SWEEPER ASSEMBLY (SE4)
1. Push one of the drum axles onto either of the
two gearcase output shafts. If necessary, rotate
the drum axle until the clevis pin hole in the axle
aligns with the matching hole in the gearcase
output shaft.
2. Use a clevis pin and hitch pin to secure the drum
axel to the shaft.
3. Slide the recessed end of a sweeper drum
assembly over the assembled axle, and then
push the drum down the axel until it bottoms at
the clevis pin.
(1) Clevis Pin
(2) Hitch Pin
(3) Cotter Pin
(4) Drum Axle
(5) Drum Assembly
The two drum assemblies are identical, but each
drum must be installed with its recessed end facing
toward the gearcase.
4. Use a cotter pin to secure the drum assembly on
the axle (see inset) . The cotter pin is designed
to fit tightly against the outboard end of the
drum, so you may need to compress the drum
face slightly during installation.
5. Repeat Steps 1-4 to install the remaining axle
and drum assembly.
IMPORTANT