Zenoah Sweeper RMSZ2500 - Manual (Page 24)

24 
9. Maintenance
MA1
1. Remove the drum and axle assemblies (see
page 13), and then remove the four end cap
bolts and the end cap (the gearcase need not
be removed from the RedMax Sweeper).
2. Allow all used gearcase oil to drain into a small
container.
BURN DANGER! The gearcase and oil will be
extremely hot after use!
3. Place the RedMax Sweeper main gear flat. Refill
the gearcase with Mobil SHC 634 Synthetic
Gear Oil to the top of the main gear (60ml –
1.80zs), as shown. DO NOT OVERFILL! (MA1)
(1) End cap
(2) Main gear
4. Apply a continuous bead of loctite ultra grey
around the pilot diameter of the end cap. Install
the end cap, and then install and firmly tighten
the four end cap bolts.
5. Install the drum and axle assemblies, and then
reconnect the spark plug wire.
• Use only Mobil SHC 634 Synthetic Gear Oil.
• Do not mix other oils ar additives with the
RedMax Sweeper Gearcase Oil.
• Do not disturb the sealed end plug or bolt on the
gearcase (leakage may occur).
• Do not use the RedMax Sweeper if oil is leaking
from the gearcase. Return the machine to the
dealer for repairs.
IMPORTANT
WARNING