Leaving the setup mode, Hdylqj wkh 6hwxs 0rgh – Zebra Technologies Z6M User Manual
Page 47
Zebra Z4M/Z6M Printers User’s Guide
39
/HDYLQJ WKH 6HWXS 0RGH
You can leave the program mode at any time by pressing the SETUP/EXIT key. The
“SAVE CHANGES” display appears. There are five choices, which are described
below. Pressing the INCREMENT (+) or DECREMENT (–) key displays other
choices and pressing the SELECT key selects the displayed choice.
•
PERMANENT — Permanently saves the changes. Values are stored in the printer
even when power is turned off.
•
TEMPORARY — Saves the changes until you change them again or until power is
turned off.
•
CANCEL — Cancels all changes from the time you pressed the SETUP/EXIT key
except for darkness and tear-off settings (if they were changed).
•
LOAD DEFAULTS — Loads factory defaults.
•
LOAD LAST SAVE — Loads values from the last permanent save.