Zanussi LA VITA E BELLA ZWH7120 P - Manual (Page 6)

6
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
Using a spanner
unscrew and
remove the two
rear bottom
screws.
Slide out the two
plastic pins.
Lay the machine on its back ensuring that
the hoses are not crushed.
Place one of the
polystyrene angle
packings under
the machine.
Cover all the open
holes with the
plugs which you
can find in the
bag containing
the instruction
booklet.
Remove the
polystyrene block
(A) protecting the
motor.
Important!
Some models are provided with a bottom
cover that will be found inside the washing
machine drum.
After ensuring the
polyethylene bags
have been
removed, follow
below instruction:
Locate the bottom cover as shown in
position (C). (1).
Then push the top end to lock to the
bottom of washing machine. (2).
A
1
2
B
Very carefully
remove the front
polystyrene block
(B) by gently
pulling the
polyethylene bag
(1) downwards
then (2) out,
ensuring not to
tear the bag.
C
1
2
2
Remove the polystyrene base, set the
machine upright and unscrew the remaining
rear screw. Slide
out the relevant
pin.