ZyXEL Communications P-871M - Manual (Page 3)

3
P-871M User’s Guide
1 Hardware Connections
You can set the P-871M to work in either CO mode or CPE
mode. Follow the procedure below to complete the hardware
connections.
1.1 CO Mode
1 Set the CO/CPE switch on the rear panel to the CO side.
2 Use the included console cable to connect the CONSOLE
port to your computer’s COM port for configuration.
3 Use the included yellow Ethernet cable to connect the
ETHERNET port to your network device, such as a switch.
4 Over ISDN: Use the included gray cable with a RJ-45
connector to connect the DSL port to another P-871M in
CPE mode.
Over POTS: Use the included gray cable with a RJ-11
connector to connect the DSL port to another P-871M in
CPE mode.
3
1
2
4
5
6
CO
CPE